Bloke Fly rod blank XL50 9′ 7wt 4-piece…FULL KIT! for first time build.
Building your first fly rod with the Bloke Fly Rod Blank XL50 9′ 7wt 4-piece is an exciting project! Here’s a step-by-step guide to assembling your FULL KIT, along with tips for a successful first build.
—
1. Unbox and Organize Your Kit
Ensure your kit includes:
– XL50 blank (4-piece, 9’ 7wt)
– Reel seat (check size compatibility)
– Cork or composite grip (pre-shaped or for customization)
– Guides (single-foot or snake guides + stripping guides)
– Thread (color-matched or your choice)
– Epoxy (for guide wraps and finish)
– Tip-top guide (pre-sized for your blank)
– Hook keeper (optional)
– Ferrules (if not pre-installed)
– Rod tube (for storage)
Pro Tip: Lay out all components and dry-fit the reel seat/grip to the blank before gluing.
—
2. Assemble the Handle Section
– Dry-fit the grip and reel seat onto the butt end of the blank to ensure proper alignment.
– Secure with epoxy: Apply a small amount of rod-building epoxy inside the grip/reel seat, slide onto the blank, and rotate to spread evenly. Align the reel seat’s hoods (for the reel) perpendicular to the rod’s spine (flex point).
– Let cure (follow epoxy instructions, usually 24 hours).
Common Mistake: Avoid excess epoxy—it can squeeze out and create mess.
—
3. Install the Guides
– Find the spine: Roll the blank on a table to locate the natural spine (it will “hug” the table). Guides go on the opposite side of the spine.
– Temporary guide placement: Use masking tape to mark guide positions (spacing varies by rod; search “7wt guide spacing chart” for reference).
– Wrap guides: Use a rod wrapper or tape to hold the guide feet. Wrap thread tightly in a spiral, finishing with a “whip finish” or half-hitch knots.
– Secure wraps: Apply a thin coat of thread epoxy (e.g., Flex Coat) to lock threads.
Pro Tip: Start with the stripping guide (largest) closest to the grip, then space smaller guides toward the tip.
—
4. Attach the Tip-Top
– Test-fit the tip-top on the rod’s tip section.
– Heat the tip-top glue (or use epoxy), slide it on, and align with other guides.
—
5. Final Coat (Optional)
– Apply a second epoxy coat over wraps for durability and gloss. Rotate the rod while drying to prevent drips (a rod dryer helps).
—
6. Quality Check
– Flex the rod to ensure guides stay aligned.
– Test the reel seat and grip for comfort.
—
Tools You Might Need
– Razor blade/scissors (for thread)
– Rod wrapper (or DIY with a book and tensioned thread)
– Brush (for epoxy)
– Alcohol (to clean excess epoxy)
—
First-Timer Tips
– Watch YouTube tutorials (e.g., Flex Coat or Mudhole videos).
– Practice thread wraps on a dowel first.
– Don’t rush epoxy curing—patience prevents mistakes.
Your Bloke XL50 will be a killer 7wt for bass, saltwater, or big trout! Post-build, test it with a reel and line to admire your work. Tight lines! 🎣
Need help with a specific step? Ask away!